IIGDT Newsletter June 2017
 
 
In House Training with IIGDT

Dr. HetlandTravel to seminars often held in remote cities weighs heavily on the justification for training. Additional considerations are number of participants that require training to truly adopt GD&T across the companies landscape from design to purchasing and manufacturing finally reaching into the quality department. Plus to be totally effective, the gap between what your company understands of GD&T must also be in the vendors vocabulary so everyone is speaking the same.

The popularity of in-house sponsored training is on the increase. Training programs can be tailored and focused on your business where a general public seminar is broad based. IIGDT has delivered many in-house programs throughout the world. The basis for the 8-Tracks to GD&T Expertise can be a foundation and demonstrates a blueprint of who should be trained and why.

Finally, what better platform to bring your key personnel together with your vendors? Often the impact of proper GD&T compliance is not carried through all channels of manufacturing. Inspecting outside production should not be an exercise of inspecting in quality. Your suppliers are as key to your success as your own personnel.


IIGDT Seminar Series: August - November 2017
Seminar Locations
Minneapolis, MN Intro to Mechanical Drawings & GD&T
August 7-11, 2017 GD&T—Intermediate Principles
  GD&T—Advanced Applications
   
Santa Clara, CA Executive Overview
August 14-17, 2017 Intro to Mechanical Drawings & GD&T
  GD&T—Intermediate Principles
   
Portland, OR Executive Overview
October 2-5, 2017 Intro to Mechanical Drawings & GD&T
  GD&T—Intermediate Principles
   
Minneapolis, MN GD&T—Tolerance Optimization
October 16-17, 2017  
   
Minneapolis, MN Intro to Mechanical Drawings & GD&T
November 6-10, 2017 GD&T—Intermediate Principles
  GD&T—Advanced Applications
   

If you would like to host a Seminar Series within your community or your company, please contact Dr. Greg Hetland for more information.

For our full schedule, visit our GD&T Seminar Schedule Page!


Coming soon! IIGDT ASME Y14.5-2009 Font

IIGDT is in the final stages of developing a new font supporting ASME Y14.5-2009. Fully supports composite and multi-segment Feature Control Frames.

Uequally Disposed Profile
Statistical Tolerance
Moveable Datum Targets and Datum Targets both includes predefined popular target sizes and datums.
 

 


GD&T Chart per ASME Y14.5M-2009

Expanded use of 3D profile shown being applied to CAD models to demonstrate the effective use and interpretation of Profile call-outs.

Developed by Dr. Greg Hetland, this guide has been widely used in industry and can be found in many companies across the world.

Size: 24" (610 mm) x 36" (914 mm)

A Poster Paints a Thousand Words... Read about the History of the Chart here.

Visit the GD&T ASME Y14.5-2009 Chart on iigdt.com

GD&T Chart per ASME Y14.5M-2009

   
 
Dr. Greg Hetland

Phone: (651) 275-8952
Fax: (612) 395-5405

greg-hetland@iigdt.com
LinkedIn

IIGDT Home IIGDT

12159 Quail Avenue Ln N
Stillwater, MN 55082

iigdt.com